Note
Action
For undeneath outlet cable version:
For robot with undeneath outlet cable version,
remove the screws on the rear plate.
7
For robots with protection class
IP30 (option 3350-300)
xx2100001202
Remove the rear plate.
Note
For robots with protection class IP54 (option 3350-
540)
For robots with protection type Clean Room (op-
tion 3351-1)
Check the gasket for the rear plate.
Tip
Replace the gasket if needed.
8
For robots with protection class
IP54 (option 3350-540)
For robots with protection type
Clean Room (option 3351-1)
xx2100002435
Releasing the base bracket
Note
Action
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
1
CAUTION
For robots with protection type Clean Room
Always cut the paint with a knife and grind the
paint edge when disassembling parts of the robot!
See
Cut the paint or surface on the robot before
2
Continues on next page
348
Product manual - IRB 920
3HAC075721-001 Revision: C
© Copyright 2022 ABB. All rights reserved.
5 Repair
5.5.1 Replacing the inner arm
Continued
Summary of Contents for IRB 920
