Recommended actions
Reload the module containing the declaration of
arg
.
Re-establish the connection with the I/O device. Re-connect
the RAPID program defined signal using AliasIO.
41861, Cyclic bool has been removed
Description
Failure while evaluating the Cyclic bool
arg
.
Consequences
The evaluation of
arg
has beem stopped immediately and the
Cyclic bool has been removed.
Probable causes
The module containing the declaration of
arg
has been
unloaded. An I/O signal needed to evaluate the logical
expression connected to
arg
has been lost (see earlier error
logs). The I/O signal that is updated with the cyclic bool value
has been lost.
Recommended actions
Reload the module containing the declaration of
arg
.
Re-establish the connection with the I/O device. Re-connect
the RAPID program defined signal using AliasIO. Re-connect
the logical expression.
41862, ASCII log setup failed
Description
Not possible to setup ASCII log for the cyclic bool
arg
.
Probable causes
The cyclic bool is not active when activation of ASCII log is
done with RAPID instruction StartAsciiLog.
Recommended actions
Use RAPID instruction SetupCyclicBool using cyclic bool
arg
before using StartAsciiLog.
41863, Mechanical unit not TCP robot
Description
Task:
arg
.
The mechanical unit
arg
is not a TCP robot.
arg
can only be
used if the mechanical unit is a TCP robot.
Program ref:
arg
.
Consequences
The program execution is stopped immediately.
Recommended actions
Use
arg
with TCP robot only.
41864, Argument error
Description
Task:
arg
.
Bad combination of switches.
The switch
arg
can only be combined with switch
arg
.
Program ref:
arg
.
Consequences
The program execution is stopped immediately.
Recommended actions
Correct the RAPID program.
41865, Invalid MAC address
Description
Task:
arg
.
Invalid MAC address
arg
.
Program ref:
arg
.
Consequences
The program execution is stopped immediately.
Probable causes
The format might be wrong.
Recommended actions
Check the MAC address and correct the address used.
The length of the MAC-address in format XX:XX:XX:XX:XX:XX.
41880, AliasCamera Define Error
Description
Task:
arg
.
The camera in argument CameraName or FromCamera:
arg
,
must be defined in the Communication configuration (SIO,cfg)
and the camera in argument ToCamera:
arg
, must be declared
in the RAPID program and not defined in the Communication
configuration (SIO,cfg).
Program ref:
arg
.
Recommended actions
Check the Communication configuration and the RAPID
program.
Recovery:
arg
.
41881, Persistent boolean Break
Description
Task:
arg
.
A value change on a persistent boolean variable interrupted
the execution.
Program ref:
arg
.
Continues on next page
Operating manual - Troubleshooting IRC5
319
3HAC020738-001 Revision: AA
© Copyright 2005-2018 ABB. All rights reserved.
5 Troubleshooting by event log
5.6 4 xxxx
Continued
Summary of Contents for IRC5 Compact
