Refitting the movable chain end
Use this procedure to refit the movable chain end.
Refitting the movable chain end
Note
Action
Note
If any part of the cable chain tray has been re-
moved, use Loctite 243 when refitting parts. Also
note that the NYLOC nuts can only be used once.
1
xx2200000885
Refit the movable chain end to the bracket and
secure with screws.
2
Refit the movable chain end with bracket to the
cable chain.
Note
Be careful with the cables routing.
3
Screws: ISO 4762 M6x20 Class 8.8
(4 pcs)
Washers: BN 792 M6 Washer (4
pcs)
Tightening torque: 10 Nm
Replacing the inner cable chain link
on page 295
Refit the cable chain link besides the movable
chain end.
4
Replacing the outer cable chain
link on page 288
Refit the plastic link bars.
5
xx2200000882
Refit the movable chain end bracket with cables
to the carriage and secure with screws.
6
Screws: ISO 4762 M12x35 Class
8.8 (2 pcs)
Washers: BN 792 M12 Washer (2
pcs)
Tightening torque: 83 Nm
Continues on next page
Product manual - IRT 710
311
3HKA00000186299-001 Revision: B
© Copyright 2023 ABB. All rights reserved.
5 Repair
5.4.2.4 Replacing the movable chain end
Continued
Summary of Contents for IRT 710
