ABB ISO TX 6k, User Manual

9

I SO T X FOR POWE RVA LU E RT G 2 U L 5 -10 K VA

STATUS:

Approved

SECURITY LEVEL:

Public

DOCUMENT ID: 

4NWD005663

REV: 

A

LANG:

EN

PAGE:

9 / 18

© Copyright 2022 ABB. All rights reserved.

—

4 Installation 

THE SYSTEM MUST BE INSTALLED IN ACCORDANCE WITH THE 

APPLICABLE SAFETY REGULATIONS

NOTE

INSTALLATION AND COMMISSIONING SHALL BE IN COMPLIANCE WITH 

ALL APPLICABLE NATIONAL, STATE, AND LOCAL SAFETY REGULATIONS 

AND MUST BE CARRIED OUT BY SUITABLY QUALIFIED PERSONS AS PER 

NATIONAL, STATE, AND LOCAL REQUIREMENTS.

— 
4 1  Inspecting the equipment

WARNING

RISK OF FALLING: DISMANTLING THE UPS REQUIRES WORKING AT 

HEIGHT. TAKE THE NECESSARY PRECAUTIONS. 

— 
4 2  Unpacking the Unit

DANGER

UNPACKING THE UNIT IN A LOW-TEMPERATURE ENVIRONMENT MAY 

CAUSE CONDENSATION TO FORM BOTH INSIDE AND ON THE CABINET. 

DO NOT INSTALL THE  UNIT UNTIL THE INSIDE AND OUTSIDE OF THE 

UNIT ARE DRY (RISK OF ELECTRIC SHOCK).   

NOTE

IF ANY EQUIPMENT HAS BEEN DAMAGED DURING SHIPMENT, KEEP 

THE SHIPPING CARTONS AND PACKING MATERIALS FOR THE CARRIER 

OR PLACE OF PURCHASE AND FILE A CLAIM FOR SHIPPING DAMAGE. IF 

YOU DISCOVER THE DAMAGE AFTER ACCEPTANCE, FILE A CLAIM FOR 

CONCEALED DAMAGE 

DISCARD OR RECYCLE THE PACKAGING IN A RESPONSIBLE MANNER OR 

STORE IT FOR FUTURE USE.
PACKING MATERIALS MUST BE DISPOSED OF IN COMPLIANCE WITH ALL 

LOCAL REGULATIONS CONCERNING WASTE. RECYCLING SYMBOLS ARE 

PRINTED ON THE PACKING MATERIALS TO FACILITATE SORTING.