Page 4
© 2021 ABB. All rights reserved.
Version 1.0
Introduction
This manual is intended as a guide in assisting equipment understanding and installation. This configuration of
the Slimline Power system (SPS) has one SPS Rectifier module and two Converter modules delivering
-
42 to
-
57VDC
at 100VA power Per Channel. This shelf has a total of 16 Output DC Channel with each Converter module having 8
Output channel, each output channel can support 100VA with individual LED status. The SPS Power express (PE)
shelf takes an input AC voltage of 100
-
120VAC 15A or 200
-
240VAC 7.5A which is fed to a single SPS rectifier unit.
The Slimline power system are available in four different configurations with battery/without battery for IEC
-
C19
or terminal block AC input connector type described in table 1 below. It supports a shelf Alarm card for shelf
status and fault indications with a controller. The AC input and DC output connections are available at the rear side
of the panel.
The Slimline power system shelf with IEC–
C19 AC input measures (44mm (1.73") x 440.7mm (17.35") x 300.22mm
(11.82”)
(H x W x D). The Slimline power system shelf with Terminal block AC input measures (44mm (1.73") x
440.7mm (17.35") x 335.02mm
(13.19”)
(H x W x D).
SPS Shelf variants with Part number
Description
J2007003L301CB
SPS POWER EXPRESS SHELF WITH BATT
J2007003L301C
SPS POWER EXPRESS SHELF NO BATT
J2007003L301AB
SPS POWER EXPRESS IEC
-
C19 SHELF WITH BATT
J2007003L301A
SPS POWER EXPRESS IEC
-
C19 SHELF NO BATT
Table 1: SPS Shelf Variants
Figure 1: SPS Shelf front and rear view
Controller
Alarm card
Converter 1
Converter 2
Rectifier
Phoenix terminal block
(AC Input)
Phoenix terminal block
16 Channel DC Outputs
Alarm Connections
IEC
-
C19
(AC Input)
16 Channel DC Outputs
Alarm Connections
SPS Shelf
-
front view
SPS Shelf with terminal block connector
-
rear view
SPS Shelf with IEC–
C19 connector
-
rear view
Battery Connection
Battery Connection
QUICK START GUIDE
