Page 6
© 2021 ABB. All rights reserved.
QUICK START GUIDE
Step 9
-
Set Jumpers
-
LAN Port and Relay per Galaxy Pulsar Edge Controller
Quick Start Guide
-
Skip if no Controller
See Galaxy Pulsar Edge Controller Quick Start Guide
1.
Set Jumpers
-
LAN Port and Relay
Step 10
-
Install Controller
-
Skip if no Controller
Controller installs to Controller Backplane
-
inside
on the right.
1.
Remove nut
-
8mm (5/16)
2.
Align Controller with the backplane connector.
3.
Slide controller firmly to the left.
CAUTION: DO NOT press on LEDs or LCD.
4.
Secure with nut
-
8mm (5/16)
Step 11
-
Set Shelf IDs per Galaxy Pulsar Edge Controller Quick Start Guide
Skip if Stand
-
alone Distribution
Step 12
-
Install Controller Communications Cables
-
Skip if Stand
-
alone Distribution
Controller in Rectifier Shelf
1. Connect the communication cable between Distribution Shelf and adjacent Rectifier Shelf (cable provided).
2. Install other controller communications cables (alarm, LAN, etc.) per Rectifier Shelf Quick Start Guide.
Controller in Distribution Shelf
1. ABB Device Comm cable
a. Route cable out of the shelf through the Control Cable Bushing.
b. Connect cable to the adjacent Rectifier Shelf.
2. Controller Backplane connections.
a. J1
-
2 Alarms
-
detachable block
-
Wire to office alarms and signals.
See Information: Alarm Connections for alarm connection details
b. J5 LAN
-
Connect to Ethernet network.
Controller Backplane
Controller
Nut