Operation Manual / Power2 845-M / 4 Product description
1 Introduction / 1.5 Warning plates on the low-pressure and high-pres-
sure stage
© Copyright 2020 ABB. All rights reserved.
HZTL4070_EN
Rev.C
January 2020
1.5
Warning plates on the low-pressure and high-
pressure stage
Warning plates are affixed at the following locations of the high and low-pressure stage:
Fig. 6: Locations of Power2 LP warning plates
Fig. 7: Locations of Power2 HP warning plates
If warning plates are not present in the designated locations or not readable, proceed as fol-
lows:
u
Order new warning plates from ABB Turbocharging Service Stations.
u
Remove any warning plates that have become unreadable.
u
Clean and degrease the areas designated for the warning plates.
u
Fit new warning plates and remove protective sheets.
Non-insulated high and low-pressure stages
High and low-pressure stages supplied to the enginebuilder without insulation must be
equipped later with warning plates to be attached to the insulation. This is the responsibility
of the enginebuilder.
Page
10
/
57
