10
A B B U PS PRODUC TS A N D SOLUTI ON S
—
3.2.3.2-1
—
3.2.3.2-2
—
3.2.3.2-1:
Battery module
connection
—
3.2.3.2-2:
Battery module
connection
1. Install the ear bracket onto the unit using the
M4 flathead screws (figure 3.2.1-1).
2. Slide the unit into the rail kit and make sure to
tighten the rack-mounting screw
(figure 3.2.1 -3).
3. After installing the UPS into the rack, proceed
with the connection of the load to the UPS.
Make sure the load devices are turned off
before plugging them into the output
receptacles.
3 .2 .3 .2 External battery modules
WARNING
DO NOT PILE UPS AND EBM ENCLOSURES,
THEY MIGHT FALL OVER. THE PICTURE
BELOW REPRESENTS JUST A SIMPLIFIED
CONNECTION DIAGRAM.
Identify the final position and keep 2U spacing for
this installation; it is recommended that this
spacing is provided below the UPS.
1. Install the ear bracket onto the unit with the
flathead M4 screw. (figure 3.2.1-1).
2. Slide the unit into the rail kit and make sure
to tighten the rack-mounting screw
(figure 3.2.1-3).
3. Connect the EBM to the UPS with the battery
power cable (figure 3.2.3.2-1).
4. Install fixing plate to fix battery cable
(figure
3.2.3.2-2)
NOTE
UP TO FOUR
EXTERNAL BATTERY
ENCLOSURES CAN BE CONNECTED TO
THE UPS IN THE SAME WAY AS
SHOWN ABOVE.
