04-3598_ABB_PVA11_T_1-3kVA_EN_REV-B.doc
Page 6/29 ABB
Modifications reserved
1 SAFETY INSTRUCTIONS
1.1
Operator precautions
The user must follow the precautions and only perform the described operations. Also in these measures
the operator of the UPS System must adhere to the instructions in this manual. Any deviation from the
instructions could be dangerous to the user or cause accidental load loss.
1.2
Environmental Considerations
To operate the UPS at the best efficiency point, your installation site should meet the environmental
parameters outlined in this manual. Excessive amount of dust in the operating environment may cause
damage or lead to malfunction. The UPS should be always protected from the outside weather and
sunshine and the operating environment must meet the weight, airflow, size and clearance requirements
specified in the technical datasheet. Under no circumstances, the UPS should be installed in an airtight
room, in the presence of flammable gases, or in an environment exceeding environmental requirements
here below.
An ambient temperature of +20°C to +25°C is recommended to achieve a long life of the UPS and
batteries. The cooling air entering the UPS must not 45 °C and the humidity should be below
90% (non-condensing)
.
1.3
Declaration of Safety conformity
PowerValue 11
is designed, manufactured and commercialized in accordance with the standard
EN ISO
9001
of Quality Management Systems. The marking shows the conformity to the EEC Directive by
means of the application of the following standards in accordance with the specifications of the
harmonized standards:
• 2006/95/EC
Low voltage directive.
Standards as reference:
• EN-IEC 62040-1
. Uninterruptible power supply (UPS). Part 1-1: General and safety requirements for
UPS’s used in accessible areas by end users.
• EN-IEC 60950-1
. IT equipment. Safety. Part 1: General requirements.
•
2011/65/EU
Restriction of the use of certain hazardous substances (RoHS) DIRECTIVE
The supplier’s responsibility is excluded in the event of any modification or intervention in the product by
the customer’s side.
Product Standards
Standards
RoHS
IEC/EN50581:2012
IEC/EN50581:2012
WARNING!
THE SUPPLIER DOES NOT TAKE ANY RESPONSIBILITY FOR
DAMAGES CAUSED THROUGH WRONG MANIPULATIONS OF THE UPS
SYSTEM.
WARNING!
IT IS PROHIBITED TO REMOVE ANY SCREWS FROM THE UPS
SYSTEM AS THERE IS DANGER OF ELECTRICAL SHOCK.
WARNING!
BEFORE CONNECTING THE MAINS YOU MUST ENSURE THAT THERE
IS A PROPER EARTH CONNECTION!
