6 Softstarters Type PSTX30...PSTX1250 User Manual short form 1SFC132082M9901
EN
3 Mounting
The PSTX softstarters has different sizes that you can install with M6
bolts, or bolts with the same dimension and strength.
1. Find the correct drawing with dimensions for your softstarter
and make sure that you have the correct drilling plan.
Drilling plan is also printed on the box.
2. If the softstarter is installed in an enclosure, make sure that the
enclosure size is not smaller than the minimum recommended.
Select the size from the applicable table for IEC or
.
3. Make sure that the distance to the wall and the front, and the
installation angle meet the requirements.
4.
Make sure that there is free flow of air through the product.
5. You can remove the HMI and use it as a remote control. Drill a hole
where you want to install the HMI. Use RJ45 cable between the HMI
and the softstarter. The maximum cable length is 3 m.
Roll together the remaining cable to prevent blockage of the door.
Use the provided cable or another non shielded RJ45 cable.
Shielded cables should not be used.
Risk of damage to property. Make sure that no liquids, dust or
conductive parts can go into the softstarter.
If you do not obey these instructions, this can cause the softstarter to
become overheated or not operate correctly.
03
05
06
02
04
