Operation Manual / Power2 340-H / Low-pressure stage
2 Safety / 2.7 Warning plates on the low-pressure stage
© Copyright 2022 ABB. All rights reserved.
HZTL4053_EN
Rev.F
March 2022
2.7
Warning plates on the low-pressure stage
Warning plates are affixed at the following locations:
Fig. 6
Low-pressure stage
If warning plates are not present in the designated locations or not readable, proceed as fol-
lows:
u
Order new warning plates from Turbo Systems service stations.
u
Remove any warning plates that have become unreadable.
u
Clean and degrease the areas designated for the warning plates.
u
Fit new warning plates and remove protective sheets.
Non-insulated high and low-pressure stages
High and low-pressure stages supplied to the enginebuilder without insulation must be
equipped later with warning plates to be attached to the insulation. This is the responsibility
of the enginebuilder.
Page
18
/
122
Summary of Contents for PT003924
Page 2: ......
