Operation Manual / Power2 340-H / Low-pressure stage
9 Disassembly and assembly / 9.2 Material required
© Copyright 2022 ABB. All rights reserved.
HZTL4053_EN
Rev.F
March 2022
9.2
Material required
Customer spare part set
Before starting work, make sure the required customer spare part set is available (see
chapter
).
Customer tool set
Before starting work, make sure the required tool set is available (see chapter
).
Not all tools are marked with a part number. Identification is guaranteed by the tool list. This
list is enclosed with the tool set.
WARNING
Servicing the tools
The tools must be checked for damage before and after use.
u
Visually inspect for corrosion, cracks, deformation and wear.
u
Damaged tools must no longer be used and must be replaced.
Identification of the assembly devices
Not all assembly devices are marked with a part number. Identification is guaranteed by the
tool list. This list is enclosed with the toolbox.
WARNING
Servicing the assembly devices
Assembly devices must be checked for damage before and after use.
u
Visually inspect for corrosion, cracks, deformation and wear.
u
Damaged assembly devices must no longer be used and must be re-
placed.
Definition of terms
¡
Suspension point
Defined loading point on a component or an assembly (blind hole thread, eyelet, lug).
¡
Assembly device
Devices that are fitted on the low-pressure or high-pressure stage in order to obtain a
suspension point. Assembly devices are specially constructed and designed for the
defined use; they are not commercially available products. Use assembly devices only for
the described applications.
¡
Lifting gear
Equipment for the lifting and transporting of loads (lifting slings, chain block, crane).
Lifting gear is not supplied by Turbo Systems.
Page
67
/
122
Summary of Contents for PT003924
Page 2: ......
