Operation Manual / Power2 850-M / High-pressure stage
2 Safety / 2.10 Lifting of loads
© Copyright 2022 ABB. All rights reserved.
HZTL4063_EN
Rev.F
March 2022
2.10
Lifting of loads
WARNING
Suspended loads
Loads that are not attached according to regulations can cause injury to
personnel or fatal accidents.
u
Loads must always be fastened to properly functional lifting gear with a
sufficient load limit.
u
Pay attention to the correct attachment of loads on the crane hook.
u
People must not stand beneath suspended loads.
Wear safety gloves to protect against mechanical hazards.
Wear safety helmet.
Fig. 9: Attachment of loads on the crane hook
Fig. 10: Attachment angle
If there are two or more suspension points, the attachment angle of 45° must not be ex-
ceeded. This prevents excessive loading due to diagonal pull.
u
Before looping around the components of the low-pressure and high-pressure stage, al-
low them to cool down (maximum 80 °C).
u
Attach components of the low-pressure and high-pressure stage as described in the re-
spective action steps.
u
Use a suitable edge guard if there are sharp edges.
u
The assembly devices must be completely screwed in and must not unscrew during use.
u
Use assembly devices only for the described applications.
u
Put down dismantled components of the low-pressure and high-pressure stage in such a
way that they cannot tip over.
Page
21
/
104
Summary of Contents for PT004165
Page 2: ......
