Operation Manual / Power2 850-M / High-pressure stage
2 Safety / 2.12 Hazards during operation and maintenance
© Copyright 2022 ABB. All rights reserved.
HZTL4063_EN
Rev.F
March 2022
WARNING
Hot surfaces on the non-insulated low-pressure and high-pressure stage
Non-insulated low-pressure and high-pressure stages can cause serious in-
juries to personnel (burns).
Turbo Systems supplies the low-pressure and high-pressure stage with or
without insulation in accordance with the purchase order received from the
enginebuilder. If supply is without insulation, the enginebuilder is respons-
ible for providing the low-pressure and high-pressure stage with proper in-
sulation and for providing protection against contact with hot surfaces.
u
Compliance with the instructions and specifications given by the en-
ginebuilder to protect against contact with hot surfaces on the low-pres-
sure and high-pressure stage is compulsory.
Wear safety gloves to protect against thermal hazards.
Hazards due to rotating parts
WARNING
Physical hazards due to rotating parts
Contact with rotating parts can cause severe injury. The low-pressure stage
must never be used without the filter silencer or air inlet casing, respectively.
With the engine stopped, the rotor can rotate due to the stack draught
alone.
u
Operate the low-pressure and high-pressure stage in compliance with the
specifications.
u
Secure the rotor against unintentional rotation during maintenance.
Wear safety gloves to protect against mechanical hazards.
Page
24
/
104
Summary of Contents for PT004165
Page 2: ......
