Terminal
Description
PCM600 info
Hardware module
instance
Hardware channel
X326-4
X326-5
Power output 3, normally open
BIO_4
BO3_PO
X326-6
Table 543:
Output contacts X331, 3U full 19”
Terminal
Description
PCM600 info
Hardware module
instance
Hardware channel
X331-1
Power output 1, normally open
BIO_5
BO1_PO
X331-2
X331-3
Power output 2, normally open
BIO_5
BO2_PO
X331-4
X331-5
Power output 3, normally open
BIO_5
BO3_PO
X331-6
Table 544:
Output contacts X336, 3U full 19”
Terminal
Description
PCM600 info
Hardware module
instance
Hardware channel
X336-1
Power output 1, normally open
BIO_6
BO1_PO
X336-2
X336-3
Power output 2, normally open
BIO_6
BO2_PO
X336-4
X336-5
Power output 3, normally open
BIO_6
BO3_PO
X336-6
18.3.2
Outputs for signalling
Signal output contacts are used for signalling on starting and tripping of the IED. On
delivery from the factory, the start and alarm signals from all the protection stages are
routed to signalling outputs. See connection diagrams.
Each signal connector terminal is connected with one 0.5...2.5 mm
2
wire or with two
0.5...1.0 mm
2
wires.
Section 18
1MRK 502 048-UEN A
IED physical connections
666
Technical manual
Summary of Contents for REG650 ANSI
