1. SCL files are exported from PCM600. In this case, a SCD file. It is also possible
to export other SCL file types.
2. Horizontal and vertical communication is configured using the station
configuration tool, for example, IET600.
3. SCL files are imported to a PCM600 project. In this case, it is the updated SCD
file.
SCD file
do IED engineering
export SCD file
PCM600 (1)
create project
import SCD file
configure data sets
configure Report CBs
configure GOOSE CBs
export SCD file
IET 600
(2)
import SCD file
link GOOSE input data
Write to IED
PCM600 (3)
SCD file
IED 1
IED n
IED 2
IED n -1
GUID-5096E041-8757-49F2-BB8D-D02B6222C359 V1 EN
Figure 77:
IEC 61850: Signal engineering procedure flow
7.3
Exporting SCL files from PCM600
A pre-condition is that all IEDs in the project must be engineered in PCM600. The
hardware interface, for example the communication port, has to be selected and
configured. The used interface addresses have to be set according to protocol and
project definitions. The station communication port has to be activated in the IED, that
is to set the IEC61850-8-1
Operation
setting to “On”.
7.3.1
Exporting SCD files
1.
Select the station in the plant structure.
1MRS756800 F
Section 7
IEC 61850 communication engineering
630 series
105
Engineering Manual
