Section 1
Introduction
1.1
This manual
The engineering manual contains instructions on how to engineer the IEDs using the
different tools in PCM600. The manual provides instructions on how to set up a
PCM600 project and insert IEDs to the project structure. The manual also recommends
a sequence for engineering of protection and control functions, LHMI functions as well
as communication engineering for IEC 60870-5-103, IEC 61850 and DNP3.
1.2
Intended audience
This manual addresses system and project engineers involved in the engineering
process of a project, and installation and commissioning personnel, who use technical
data during engineering, installation and commissioning, and in normal service.
The system engineer must have a thorough knowledge of protection and/or control
systems, protection and/or control equipment, protection and/or control functions and
the configured functional logics in the IEDs. The installation and commissioning
personnel must have a basic knowledge of handling electronic equipment.
1MRK 511 245-UUS -
Section 1
Introduction
650 series ANSI
5
Engineering Manual
