IEC08000121-2-en.vsd
IEC08000121 V2 EN
Figure 27:
Alternative 2: IP address via IED Object Properties window
Procedure
1. Select the IED to enter the IP address.
2. Open the
Object Properties
window.
3. Place the cursor in the
IP address
row and enter the IP address.
The used alternative depends on the time at which the IP address is available.
4.7
Setting technical key
Both a physical IED and an IED object in PCM600 have a technical key. The purpose
of the technical key is to prevent download of a configuration to wrong IED. The
technical key in the IED and PCM600 must be the same, otherwise it is not possible to
download a configuration. Each IED in a PCM600 project must have a unique
technical key. It is therefor not possible to set the same technical key for several IEDs
in the same PCM600 project.
The IED is delivered with a factory default technical key. The
validation of the technical keys between PCM600 and the IED will not
occur if the IED contains the factory default technical key.
1MRK 511 245-UUS -
Section 4
Setting up a project
650 series ANSI
49
Engineering Manual