9.2.7.9
Event function
Main menu/Settings/General settings/Monitoring/EventFunction/EVENT:x
The Event function menu consists of several sets of settable parameters EVENT
where the SPA channel mask, LON channel mask, Event mask and minimum
repetition interval can be set.
9.2.7.10
Logical signal status report BINSTATREP
Main menu/Settings/General settings/Monitoring/BinarySignalStatusReport/
BINSTATREP:x
The Binary signal status report BINSTATREP settings consist of some sets of
settable parameters with one settable parameter per instance.
9.2.7.11
IEC 60870–5–103
Main menu/Settings/General settings/Monitoring/IEC 60870–5–103
The IEC 60870–5–103 part of the settings menu is divided into two separate
submenus. These are Measurements and Disturbance report. In the Measurements
menu there are four sets of measurement settings, one with standard settings and
three with user defined settings. The standard settings include some standard
service value thresholds.
In the Disturbance report menu Binary signal parameters on up to 96 channels are
configured.
9.2.8
Metering
9.2.8.1
Overview
Under metering there are settings for the Pulse counter function. There are some
instances of the Pulse counter function. Each instance can be switched on or off
and a number of parameters can be adjusted.
9.2.8.2
Pulse counter logic PCGGIO
Main menu/Settings/General settings/Metering/PulseCounter(PCGGIO)/
PCGGIO:x
In the Pulse counter PCGGIO folder there are a number of instances of the pulse
counter function PCGGIO. Each instance has a setting and some settable
parameters. The setting
Operation
is used to turn the function on or off. The
parameters are adjusted to change cycle times, pulse counter criteria and the like.
Section 9
1MRK505209-UEN E
Read and change settings
54
Operator's manual