ABB | SACE Emax 2
Electronic accessories | 16 - Other accessories
247 | © 2017 ABB | 1SDH001330R0002 - ECN000058721 Rev. A
Ekip Signalling 10K modules
The Ekip Signalling 10K is an accessory module for external signaling that can be installed on a standard 35
mm DIN rail (DIN EN 50022 type TS 35x15 mm).
This module has:
• Ten programmable output contacts.
• Ten or eleven programmable digital inputs.
• A power-on LED, and twenty or twenty-one signalling LEDs (one for each output/input).
The module can be set-up in four different configurations:
• One in case of connection to a Link bus network.
• Three configurations in case of connection via Local Bus (to allow up to three modules to be connected
to the same trip unit).
The module can be supplied by 110...240 V AC / DC or 24...48 V DC.
Further information on Ekip Signalling 10K is available on the website http://www.abb.com/abblibrary/
DownloadCenter/, in particular in the manual
.
IMPORTANT: make sure that you have read the recommendations concerning security
and prevention from unauthorized access.
Ekip Signalling Modbus TCP
The Ekip Signalling Modbus TCP is an external accessory module that can be installed on a standard 35 mm
DIN rail (DIN EN 50022 type TS 35 x 15 mm).
Its function is to share, via an Ethernet network with Modbus TCP communication protocol, information about
the state of circuit-breakers that may even be without the capability to provide such information via Ethernet,
and to allow these circuit-breakers to be operated via remote control.
The module has 11 digital inputs and 10 output contacts:
• The inputs allow the state of the circuit-breakers and other information to be monitored.
• The outputs allow the circuit-breakers to be operated.
Each input and output is associated with a state LED.
The module can operate in three modes:
Mode
Characteristics
CB Supervisor
The module can be associated with a single circuit-breaker, which can be
selected from a list. Configuration of the inputs and output is pre-defined.
Multi MCCB Supervisor
The module can be associated with up to five circuit-breakers.
Configuration of the inputs and output is pre-defined.
NOTE:
mode available with moulded case circuit-breakers
.
Free I/O
The inputs and outputs can be fully configured by the user.
The module can be supplied by 110...240 V AC / DC or 24...48 V DC.
Further details about Ekip Signalling Modbus TCP are available on the website http://www.abb.com/
abblibrary/ DownloadCenter/, in particular in the manual
Summary of Contents for SACE Emax E1.2
Page 2: ...ABB SACE Emax 2 2 2017 ABB 1SDH001330R0002 ECN000058721 Rev A ...
Page 8: ...VI 2017 ABB SACE Emax 2 1SDH001330R0002 ECN000058721 Rev A ...
Page 9: ...ABB SACE Emax 2 3 2017 ABB 1SDH001330R0002 ECN000058721 Rev A ...
Page 310: ...ABB SACE Emax 2 304 2017 ABB 1SDH001330R0002 ECN000058721 Rev A Service 1 Power Care ...
