SM500F
Field mountable paperless recorder
7 Configuration
IM/SM500F Rev. Z
117
7.10 I/O Module Configuration
7.10.1 Analog Inputs
Fig. 7.17 I/O Module Configuration
Note.
The recorder detects the type of module fitted in each position automatically.
Set the mains rejection frequency used to filter electrical noise induced on
the signal lines by power supply cables.
Set to 'On' to enable input adjustment from Logging menu – see page 50.
Note.
The following parameter is displayed only if recording is enabled
during configuration, i.e. the 'Disable recording in configuration' check
box is
not
ticked on entry to the Configuration level – see Fig. 7.1,
I
nput Adjustment
Manually fine-tune inputs to remove process offset errors or system scale
errors.
Note.
Changes to the Analog Input Type (see page 96) must be saved to
the current configuration before commencing input adjustment.
For dual input modules, 2 channels can be adjusted.
