SM500F
Field mountable paperless recorder
7 Configuration
80
IM/SM500F Rev. Z
7.6.5 Users
Note.
User 1 is the System Administrator and is able to change user names/access privileges and
enter initial passwords for all other users.
if 'Security system' is set to 'Basic' (see Section 7.6.4, page 78) other users (if enabled by
User 1) can change their user name, password and access privileges.
if 'Security system' is set to 'Advanced' (see Section 7.6.4, page 78), other users cannot
change their user names and access privileges once set by User 1, but all users may change
their own passwords.
The following parameters are displayed only if 'Security system' is set to 'Basic' – see
Section 7.6.4, page 78.
Enter a name and password for User 1.
Note.
User 1 only is able to access this parameter.
User 1 can enter names and associated passwords to enable up to 3
additional users access to the Configuration level.
Note.
If enabled by User 1, another user can access their associated
parameter and change the 'Name', 'Password' and 'Access' settings.
However, if 'Access' is set to 'Disabled' by that user and the configuration
saved, only User 1 can restore that user's access privileges.
Enter a name for the selected user.
Enter an initial password for the selected user.
Set access privileges for the selected user.
Enabled – The selected user is able to access the Configuration level.
Disabled – The selected user is unable to access to the Configuration
level.
Note.
When the method of access to the Configuration level is set to
'Password protected' (see Section 7.6.4, page 78) and a user with
Configuration level access privileges changes the recorder's
configuration, the 'Name' of the user is included in the audit log entry.
