4
R E L AY R ETROFIT PROG R A M CUT TI NG TOOL
O P ER AT I N G G U I D E SPACO M 3 0 0
—
3. Operating the cutting tool on a horizontal edge
Ensure that the cutting head is set in the correct
position. The text
HORIZONTAL Up and Down
must
point in the direction you are cutting.
Make four punches, side by side.
Ensure that you use the correct guiding,
before each cutting cycle.
After each cutting cycle, ensure that thecutting head
is clear of offcut!
3.1
3.2
3.3
