26 CI/EDP300-EN Rev. A |
D500
7.2.4
Switching the operating mode
The operating mode is displayed and changed in the operating
modes menu.
Additionally, it is possible to switch to the configuration level
from there.
Process display
1.
Use
to switch to the operating modes menu.
Operating Mode
Auto
Adjust
O Adaptive
O Control
O Manual
SP
O Manual
Sensor
Configuration
Back
OK
2.
Use
or
to select the required operating mode.
3.
Use
to confirm your selection.
7.2.5
Switching to the configuration level
(parameterization)
The device parameters can be displayed and changed on the
configuration level.
Operating Mode
Auto
Adjust
O Adaptive
O Control
O Manual
SP
O Manual
Sensor
Configuration
Back
OK
4. Use
or
to select the "Configuration" operating
mode.
5.
Use
to confirm your selection.
7.2.6
Selecting and changing parameters
Entry from table
When an entry is made from a table, a value is selected from a
list of parameter values.
Menu Name
Parameter Name
Actual Value
Next
Edit
1.
Select the parameters you want to set in the menu.
2.
Use to call up the list of available parameter values.
The parameter value that is currently set is highlighted.
Parameter Name
Parameter 1
Parameter 2
Parameter 3
Cancel
OK
3.
Use
or
to select the required value.
4.
Use
to confirm your selection.
This concludes the procedure for selecting a parameter value.
Numerical entry
When a numerical entry is made, a value is set by entering the
individual decimal positions.
Menu Name
Parameter Name
12.3456 [Unit]
Next
Edit
1.
Select the parameters you want to set in the menu.
2.
Use
to call up the parameter for editing. The position
that is currently selected is highlighted.
Parameter Name
12.3456 [Unit]
Next
OK
3.
Use
to select the decimal position to be changed.
4.
Use
or
to set the required value.
5.
Use
to select the next decimal position.
6.
If necessary, select and set other decimal positions using
the same procedure as described in steps 3 and 4.
7.
Use
to confirm your settings.
This concludes the procedure for changing a parameter value.
