D500
| CI/EDP300-EN Rev. A 7
1.7
Installation safety instructions
CAUTION – Minor injuries
Incorrect parameter valves can cause the valve to
move unexpectedly. This can lead to process
failures and result in injuries.
Before recommissioning a positioner that was
previously in use at another location, always reset
the device to its factory settings. Never start Auto
Adjust before restoring the factory settings.
— Only qualified specialists who have been trained for these
tasks are authorized to mount and adjust the unit, and to
make the electrical connection.
— When carrying out any work on the device, always observe
the local accident prevention regulations and the
regulations concerning the construction of technical
installations.
1.8
Safety instructions for electrical installation
The electrical connection may only be established by
authorized specialist personnel and in accordance with the
electrical circuit diagrams.
The electrical connection information in this manual must be
observed; otherwise, the type of electrical protection may be
adversely affected.
Safe isolation of electrical circuits which are dangerous if
touched is only ensured if the connected devices satisfy the
requirements of DIN EN 61140 (VDE 0140 Part 1) (basic
requirements for safe isolation).
To ensure safe isolation, install supply lines so that they are
separate from electrical circuits which are dangerous if
touched, or implement additional isolation measures for them.
1.9
Safety instructions for operation
Before switching on the device, make sure that your
installation complies with the environmental conditions listed in
the chapter “Technical Data” or on the data sheet.
If there is a chance that safe operation is no longer possible,
take the device out of operation and secure it against
unintended startup.
Prior to installation, check the devices for possible damage
that may have occurred as a result of improper transport.
Details of any damage that has occurred in transit must be
recorded on the transport documents. All claims for damages
must be submitted to the shipper without delay and before
installation.
1.10
Returning devices
Use the original packaging or a secure transport container of
an appropriate type if you need to return the device for repair
or recalibration purposes.
Include the return form once it has been properly filled out (see
appendix in operating instructions) with the device.
According to the EU Directive governing hazardous materials,
the owner of hazardous waste is responsible for its disposal or
must observe the following regulations for shipping purposes:
All devices delivered to ABB must be free from any hazardous
materials (acids, alkalis, solvents, etc.).
Please contact Customer Center Service acc. to page 2 for
nearest service location.
1.11
Integrated management system
ABB Automation Products GmbH operates an integrated
management system, consisting of:
— Quality management system to ISO 9001:2008
— Environmental management system to ISO 14001:2004
— Occupational health and safety management system to
BS OHSAS 18001:2007 and
— Data and information protection management system
Environmental awareness is an important part of our company
policy.
Our products and solutions are intended to have minimum
impact on the environment and on people during
manufacturing, storage, transport, use, and disposal.
This includes the environmentally-friendly use of natural
resources. We conduct an open dialog with the public through
our publications.
