ABB
5:6
Approvals:
Control of:
Entire safety system based on
the dynamic safety circuit.
Features:
Easy installation
Flexible
Cost effective
Display for troubleshooting
(Vital 2 and 3)
A wide range of safety sen-
sors can be connected into the
circuit
Several safe outputs
Information output
Outputs with time delay
(Vital 2 and 3)
TÜV Nord
– Vital 1
TÜV Rheinland
– Vital 2 and 3
Vital is based on a single channel safety concept where multi-
ple safety sensors can be connected in series and monitored
with a single safety controller. A dynamic signal is sent from
Vital through all connected sensors, and then returned to Vital
which then evaluates the received signal. As each safety sen-
sor inverts the signal, it is possible to detect short circuits or
faults in any of the sensors. Vital 2 and Vital 3 are designed
for use with ABB Jokab Eden sensors, Tina components and
Spot light grids or similar products. Vital 2 and 3 are both
safety controllers with two safe input functions and two output
groups, the only difference between the two models being in
the input configuration.
Vital
Safety controller
