Commissioning
System Manual
│77
6.2.5
Outdoor station with push-buttons
Address the device via the " IP Touch 7".
1
2
Fig. 52: Outdoor station with buttons: Commissioning mode
To address the device, perform the following steps:
1. Boot up the device.
– The device boots up automatically when the power supply is connected.
– If the device is already booted up, briefly interrupt the power supply of the device. The
device reboots.
– The LED icons [1] light up permanently during the automatic boot up.
2. Activating the "Commissioning mode":
– After the LED icons [1] in the camera have stopped being lit up, keep the top doorbell
button pressed (about 11 seconds), until the LED icons [1] light up green.
– In case of several bell spaces, the first doorbell button is located below the audio
shell [2].
– If no entry is made within the next 5 minutes, the device exits the "Commissioning
mode" automatically.
3. Switch to the indoor station.
