Commissioning
System Manual 2CKA000073B9795
│45
Use the following steps to connect with the PC:
Fig. 26: System controller "Smart Access Point" in network list of the PC
1. Connect the PC with the WLAN of system controller "Smart Access Point".
– The WLAN access data are located on the device.
– Remove the cover of the device.
Fig. 27: Entering the IP address in a browser
2. Call up the start page of system controller "Smart Access Point" in the browser.
– For this, enter the IP address in the address line of the browser.
– The IP address is located next to the WLAN access data.
3. Follow the steps of the wizard.
– Select the matching mode during the course of the steps: "Residential" or "Functional",
see the introduction of the chapter.
After the successful run-through of the wizard, the WLAN of system controller "Smart Access
Point" is no longer active.