CELL-DYN
®
1800 OPTICON OPT-6125 Trigger-Activated Hand-Held Bar Code Scanner User’s Guide
9140394A—November 2008
9
NOTE:
If it is necessary to reset the scanner to factory default configuration,
scan all the following barcodes per Table 4 in succession to set the
scanner back to factory defaults.
Prepare for scanner verification.
1. Once analyzer in
Ready
state
2. From the
Main
menu, press the following softkey:
RUN / SPECIMEN TYPE / PATIENT SPECIMEN
3. With cursor in
Next ID
field, start scanning the appropriate bar codes from
section
Verifying the Configuration
.
TABLE 4 – FACTORY DEFAULTS
START
[[
USB Defaults
TV
Single Read Mode
T1
Minimum Data Lengths
ID
HG
END
[[
9140394A Book.book Page 9 Monday, November 24, 2008 12:24 PM
