CELL-DYN
®
1800 OPTICON OPT-6125 Trigger-Activated Hand-Held Bar Code Scanner User’s Guide
4
9140394A—November 2008
Configuring the Scanner:
The scanner is ready to use, in the default configuration listed below, upon
installation. Limited configuration changes can be made by using the
configuration codes in this document.
Note:
If more detailed configuration changes are needed, U.S. customers call
Abbott Customer Service at 1-877-4ABBOTT (1-877-422-2688).
Customers outside the U.S., contact your local Hematology Customer
Support representative.
Default configuration:
•
Keyboard:
English (No check digit)
•
Trigger:
Active while pressed, Standby after a good read
•
Active Symbologies:
•
Code 39
Check Digit: Not Used
Bar Length: Any Length
•
Codabar
Check Digit: Not Used
Bar Length: Any Length
•
Code 128 / EAN 128
Bar Length: Any Length
•
Interleaved 2 of 5
Check Digit: Not Used
Bar Length: Minimum Length 4
Bar Code Symbologies Supported:
•
CODE 39, with modulo 43 check digit, or without check digit
•
CODABAR, with AIM recommended check digit, or without check digit
•
CODE 128 / EAN 128
•
INTERLEAVED 2 OF 5 (I 2 of 5), minimum length 4, with mod 10 check
digit, or without check digit
Configuration Bar Codes:
The following pages contain special Configuration Bar Codes for configuring
the OPTICON OPT-6125 Trigger-Activated Bar Code Scanner. The scanner can
be configured to use all of the four supported Bar Code symbologies
(with check
digit)
for Code 39, Codabar, and I 2 of 5, or can be configured for
(No check
digit)
for Code 39, Codabar, and I 2 of 5. Code 128 is active for both choices.
9140394A Book.book Page 4 Monday, November 24, 2008 12:24 PM
