5.8 mmol/L
Chapter 5: Data Review
1.
Press
2
to select
Patient by PatID
.
2.
Press
Scan
to scan the Patient ID barcode
or manually enter the Patient ID via the
keypad (if enabled).
The monitor shows test results for a specific
patient.
If you enter the ID manually, you may be
required to enter it a second time to ensure it is
correct.
While the Patient ID may be up to 30 digits,
not all digits will fit on the display. The monitor
may also be set to truncate (ignore) selected
digits of the barcode.
3.
You can select one of the following options:
Press
1
–
Previous
Press
2
–
Next
When finished reviewing the data,
you can:
Press
Clear
to return to the
Patient ID entry screen.
Press
Menu
to return to the
Menu Mode
menu.
Press
On/Off
to turn off the monitor.
The number that appears to the right of
1-Previous
and
2-Next
on the monitor
indicates the number of tests available for
review. The display also shows:
Patient ID or Name
(
p:
prompt)
Comment Code
(Number in box)
Test Type
(Glucose)
Date and Time of test
Operator ID
(
o:
prompt
)
Note that test date and time alternates with
Operator ID.
What You See on the Display
What You Do
Comments
Note:
The following section illustrates some common settings. Depending on your institution's specific settings,
some screens will display differently or not at all. If the monitor does not display the screens shown, please
refer to Chapter 10, Troubleshooting.
Data Review for Patient by Patient ID
Please refer to the beginning of this Data Review chapter
for step-by-step instructions to access the Data Review menu.
5-4
Questions?
Refer to Page 10-9 For Technical Support Instructions.
