V56G FHD Car Recorder User Manual
8
5.
Two knobs adjust the camera’s position. Loosen the top knob on the
side of the bracket to adjust the camera’s vertical position. Loosen
the bottom knob to adjust the camera’s horizontal position.
Remove the Bracket
To remove the bracket from the windshield, release the suction cup,
hold the camera securely, and lift the suction clamp.
Connect to Power
1.
Connect the car adapter’s USB plug to the device’s USB port.
2.
Connect the cigarette lighter adapter plug to the vehicle’s cigarette
lighter port.
3.
The device turns on. Red light indicates the device being recording,
while the green light indicates the device in standby mode.
NOTE
In certain models of cars, the cigarette lighter keeps providing power
even when the engine is off. Be sure to remove the car charger or
disconnect the device when leaving the vehicle to prevent draining the
vehicle battery. Check your vehicle’s owner’s manual to determine if this
applies to your vehicle.