Industrial Tracker Reference Guide FW 1.8 V0.2
4.5.5
In actvity traciing operatng mode
config flag bits
Bit6
geolocaton start
Bit 8
Moton start
Bit 9
Moton end
Message
Beginning of moton
x
1
x
Moton Start
event
End of moton
x
x
1
Moton End
event
4.6 Shoci detecton
4.6.1
Overview
This feature enables the reportng of the shocks detected by the tracker.
The confguraton is lexible enough to detect a shock either globally or belonging to a given
directon.
4.6.2
Configuraton
The confguraton of the shock detecton is based on a single parameter called
shock_detection
. This
parameter gives the accelerometer sensitvity used to trigger the shock events.
The threshold can range from 0 to 100%. Value 0 means no detecton.
Notes
1i
The motion_sensitiiitt
parameter must be confgured (nonzero value)
2i The
shock_detection
parameter must be loter than the
motion_sensitiiitt
, othertise all
motons events are considered as shocks
4.6.3
Shoci detecton message
Upon the detecton of a shock event, the tracker triggers a LoRa message as follot:
The frst message is sent immediately tith the actual acceleraton values.
The next ones are delayed by tto minutes. In this case the reported value till be the highest shock
that occurred during this fxed period.
Page 13 of 46
10th July 2019
Restricted distribution