Example: Extract 35 frames from the archive device , but
first position the archive 10 frames from the start.
diskus% tara60 -xvo 10 35
transfer
Syntax: transfer [-n time] <vtr time> <position> <duration>
Transfers the "duration" frames from the VTR at the current
tape location "vtr time" to Diskus starting at "position." The
command returns immediately, so if you need notification, use
the -n parameter with time; this outputs a character time before
the record.
NOTE: This notify will not work with
rsh transfer.
Where -n time is:
A notification of the current
location.
Where "vtr time" is:
The timecode location on the
current tape to start the transfer.
Where "position" is:
The location on Diskus to start
recording.
Where "duration" is:
The number of frames to transfer.
Example: Transfer 30 frames from the current tape starting
at 11:34:00 to Diskus starting at 17:15.
diskus% transfer 11:34:00 17:15 30
trim
Syntax: trim <in|out> <time>
Adjust the in point or out point by the amount specified by
"time".
Example: Trim the in point by +15 frames.
diskus% trim in 15
Diskus Operations
Ethernet Commands
9100-0217-02 - SEP 95
Ethernet & SCSI
4-67
Summary of Contents for Diskus
