ABELL A-82 UHF Service Manual
- 5 -
Battery Save
Enable or shut down the power save function.
Channel Announcement
Enable or shut down the channel announcement function.
VOX Gain, VOX Delay Time
Enable or shut down the VOX function, set the sensitivity of VOX, VOX delay time is to set the
transmiting delay time after the VOX being enable.
High/Low Power
Switch the high or low power.
Beep
Enable or disable the reminding signal for power on.
Language
Choose the language for the announcement.
Alarm/ Alarm Cancel
Call for help in emergency, once enable, will have big voice of alarm. If enable the remote alarm, the
transcerver will transmit for 3 second.
Scan
Enable or disable the scan function. Before enable scan function, need to choose the channels need
scan, and preset the parameter of scan in the Scan Set area.
Scan mode
Set the control mode of scan
Priority channel: Set the channels need to listen to in priority during the scan process.
Look back time: Set the time to ruturn to the priority channel for scan
Rx dwell time: Set the stay time caused by receiving signal.
Tx dwell time: Set the stay time caused by transmiting signal.
Battery Announce
Report the battery volumn by announcement.
DTMF
PTT ID Rate: Set the transmitting rate of DTMF code
Primacy Digit Code: Adding time of primacy digit code
First Digit Delay: Set the delaytime between transmitting start and primacy DTMF code
sending(Considering system/decoder starting time). Increasing this parameter has the same effect
with “primacy digital” code increasement.
*/# Tone: increase the transmitting time for the “*” and “#” tone. In some case, the transmitting time of
these two codes must to be longer than number code, this parameter can be used. However, if the
transmitting start with the “*” and “#”, the radio CPU will choose longer one between */# Tone and
Primacy Digit Code after comparison.
D Button Assignment: Set the function and delaytime of D button
PTT ID
:
Set the transmitting mode and encode of PTT ID