OPERATING INSTRUCTIONS
Display and operating elements
1. Display
2. Status line
3. Menu line (top)
4. Menu line (bottom)
5. Power supply display
120 VAC (mains
supply)
Rotary push button
The rotary push button (8) is used to select and
change set points and parameters; it is then
tapped to save the values. Selected menu items
flash.
Turn clockwise
•
The menu is scrolled through
from left to right
•
Increase values (+)
Turn counterclockwise
•
The menu is scrolled through
from right to left
•
Reduce values (-)
Tap
•
Save a selected value
•
Select a menu item, go to the
setting level
Press (3 seconds)
•
Main switching function -
control panel on/off
Description
•
A rotary push button(8) is used to select menu items in
the menu lines (3 + 4) and to adjust settings.
•
Information is shown on a backlit display (1).
•
The Back button (9) is used to go back to a previous
menu.
6. Time switch display
7. Settings/values
8. Rotary push button
9. Back button
Back button
Press the Back button (9) to go back to a previous
menu and cancel settings. This means that the
previous values remain unchanged.
Instructions for use
•
If there is an interruption to the power sup- ply, the clock has to be reset.
•
If a new furnace is connected to the bus sys- tem of the control panel, repeat the proce dure described in
"Initial start-up".
