Step #1:Place dehumidifier on a level surface.
Step #2: Set Up Drain Line
Step #3: Plug unit into 15 amp grounded circuit.
Key Functions
1. Power Key
2. Arrow Buttons
3. Continuous Mode
4. Central Control
cont.
efrost
Do not place the unit directly on the vapor barrier.For example , use blocks or pavers to create a level
surface.
lf the unit is handled in such a manner that the compressor did not remain in the upright position,
you will need to place it on a level surface, then wait a minimum of 2 hours before turning “on".
The included drain line attaches to the unit via a compression type fitting on the discharge end of
the unit.To attach drain line, remove the compression nut and slide it over the end of the hose to
be attached to unit. Slide compression nut side of hose over the insert on the compression fitting
completely. Tighten compression nut.
Use this button to turn the dehumidifier on and off. Press once to turn the machine on. You will
Use the up and down arrow buttons to set the desired humidity setpoint on the display screen.
The setpoint can be any number between 36-90%.Creating a setpoint means that when the
To switch into a continuous mode, simply use the down arrow key to set the humidity below
36%.At this point the Cont.light should illuminate green on the display board to indicate you
have successfully switched to continuous mode.The display screen will show "Co".
When set to continuous, the dehumidifier will run constantly, regardless of the humidity level until
you turn the unit off or switch back to normal humidistat operation. If you would like to switch back
to normal humidistat operation, simply move the setpoint above 36%.
This mode is not applicable on the Guardian SNS90.
Central Control light should be off at all times when not connected to the AC.
indoor humidity is lower than the setpoint,the machine will stop automatically. Conversely, when
the indoor humidity is higher than the set level, the unit will operate. NOTE:The humidity levels
displayed are approximate only (+/-5%).
and will hear one beep as the machine shuts down. Note that there is a one-minutefan delay on
shutdown.
hear two beeps and the
light will illuminate green.Press the power button a second time
4
