2. Have a pattern that should be followed. For instance, you may start by covering the floor surface but
ensure that no area is repeated
3. Gently move the unit’s joysteak to turn the HVE Durable into the desired direction. This must be done
gently to avoid jerks and wheelies. It reduces delaminating or damaging the carpet
4.he equipment will drive forward and backwards and turn in a circle. It extracts with the grain of the
carpet, but when you feel the HVE durable Driver beginning to track, you will need to stop moving and
recalibrate the unit. You will need to push the joystick forward a little bit as you press the button for
calibration. Ensure you align it to the mark that indicates the button location is at the centre of the H.
5 Ensure the unit is run on the carpet but at a low speed. You may increase the speed of the carpet is
extremely wet. Check the tube leading to the horse if it indicates a small amount of water being
removed; stop extracting to reduce chances of delaminating the carpet. Also, ensure you check the
clear tube regularly as you extract.
Check
clear
take
-
up
tube
regularly during
extraction
.
Clear take
-
up
tube
Store
securely
in
upright
position
.
Secure the Rover’s ure-
thane
plastic
traction
wheels
against
wall
and
then
strap
into
place
.
Electrical
Connections
This unit
is designed
to
operate
on
a
115V
/
60
Hz electrical
con
-
electrical
outlet
is
grounded
and
that all
safety
precautions
(
outlined
on
page
1
of
this
manual
)
are
taken.
.
nection
.
Make
sure
that
the
Electric
shock
hazard
Moving
parts
hazard
WARNING
!
Turn
off
and
unplug
unit
before
servicing
or
clear
-
ing
obstructions
.
WARNING
!
Wait
for
electricity
to
dissipate
before
opening
control
box
.
Storage and Transportation
1. To prepare the unit for transportation and storage, lay it on a flat surface while the wheels are facing
up. Support the handle with one hand and pull out the pins. Fold the handle and replace the pins to
help lock the handle. The unit should then be placed on a flat surface while the power cord should be
placed on a compartment located under the unit. Besides, the arm should be placed in a cord
compartment.
To load it on a truck, use the front loading wheel and the handle to carry the unit.
2. When transporting, it should be secured against the wall of the van and should be transported in an
upright position. A strong impact may damage the gear, the motor or internal parts.
Warning
5
6