DETAIL B
R
O
www.abhmfg.com
E-mail: abhinfo@abhmfg.com
Architectural Builders Hardware Mfg., Inc.
1222 Ardmore Ave., Itasca, IL 60143
630.875.9900; FAX 800.9FAXABH (932.9224)
c 2012 ABH Mfg., Inc.
printed in USA
INSTALLATION INSTRUCTIONS
1. Prep door according to latch backset per template.
2. Install latch (Item 1) using either wood or machine screws (Items 2 or 3) depending on door type.
3. Take both base assemblies (Items 4 & 6) and rotate cam pin as shown in Detail “A” above. Place
pull base over-ride assembly (Item 4) on pull side of door and slide the cam shaft through the latch
cam. Place push base locking assembly (Item 6) on push side of door and engage push cam onto
the pull side cam shaft.
Both privacy cam pins must be at the 12 o’clock position in order for
the privacy cam shafts to interlock as shown in Detail “B”.
Check that they are interlocked
properly by rotating one privacy cam and making sure the other side is rotating at the same time.
4. Fasten both side using (4) ¼-20 machine screws and lock nuts (Items 5 & 7). Test both handles for
free movement of the latch bolt before tightening all screws. If latch bolt does not extend or retract
freely because of any type of binding, loosen screws to align adjustment of base assemblies and
retighten screws one at a time while checking for proper latch retraction. Mounting hardware (Items
5 & 7) must be tightened before proceeding to next step.
5. Place over-ride cover assembly (Item 8) on the pull side of the door making sure that the forks on
the inside of the cover engages the privacy cam and fasten with (2) 8-32 screws (Item 2).
6. Repeat Step 5 with locking cover (Item 9) on the push side of the door.
PARTS LIST
DESCRIPTION
QTY
ITEM
LATCH
1
1
8-32 X 3/8" FHMS U/C
6
2
#8 X 3/4" FHWS
2
3
PULL BASE OVER-RIDE ASSY
1
4
1/4-20 X 2-1/2" PH. TRUSS HD. M.S.
4
5
PUSH BASE LOCKING ASSY
1
6
1/4-20 LOCKNUT
4
7
COVER ASSEMBLY (OVER-RIDE)
1
8
COVER ASSEMBLY (LOCKING)
1
9
6500 PRIVACY LATCH-PUSH SIDE THUMBTURN LOCK
6500-1-07.IDW
6500
REVISED 08-08-12
1
2
2
2
2
9
2
5
4
5
3
7
7
6
NOTE:
BEFORE MOUNTING BASE
ASSEMBLIES, CAMS MUST
BE POSITIONED PER DRAWING
SHOWN IN DETAIL 'A'
DETAIL 'A'
LATCH CAM
CAM SHAFT
8
FORK
OVER-RIDE COVER
LOCKING THUMBTURN
PRIVACY PULL
CAM SHAFT
2
3
PRIVACY
CAM SHAFTS
PRIVACY PUSH
CAM SHAFT
PRIVACY
CAM PINS
