25. Always cut down slopes; never across the face. Avoid operation on steep slopes.
Slow down on sharp turns and slopes to prevent tipping and/or loss of control.
3.02 - Assembly Instructions
CAUTION: Stand clear of bands when cutting as they could be under sufficient
tension to cause them to fly loose. Take care in removing bands and wire. They
often have extremely sharp edges and cut very easily.
To assemble the mower proceed as follows:
1. Unbolt the wheel arms and discard the mounting bracket.
2. Separate the wheel arms and remove the hardware bag secured between them.
3.
IMPORTANT: Remove the belt shields to inspect around the belt area and
under the gearbox central plate to be sure the area is clear of packing material
such as blocks of wood, paper, etc.
4. Bolt the wheel arm assemblies to the mower deck with the flat washer and locknuts.
There is no difference between left/right or front/rear. Be sure both assemblies are
securely mounted.
5. Assemble each wheel to the yokes with one bolt M14x140 and one inner bushing.
Tighten down snugly. The wheel should turn freely but have no side to side
movement.
6. Replace the belt shields.
7. Bolt up the top hitch arms
(see #5, fig. 3 & 4)
to the
outside
of the rear support
plates on the rear of the mower
(see #8, fig. 4)
.
O
PERATION
12
ABI A
TTACHMENTS
F
INISH
M
OWER
O
PERATOR
’
S
M
ANUAL
7
6
3
1
2
4
5
Fig. 3
1. inner spacer
2. top hitch plate
3. top hitch support
4. bolt
5. top hitch arm
6. linking plate
7. front support plate
9
9. lower hitch arm
Summary of Contents for ACYCMO72
Page 35: ...WARRANTY ...
Page 38: ...FINISH MOWER FRAME OPERATOR S MANUAL PARTS MANUAL 2 ABI ATTACHMENTS 06 2015 ...
Page 42: ...FINISH MOWER TRANSMISSION SPINDLE OPERATOR S MANUAL PARTS MANUAL 6 ABI ATTACHMENTS 06 2015 ...
Page 50: ...FINISH MOWER DECALS OPERATOR S MANUAL PARTS MANUAL 14 ABI ATTACHMENTS 06 2015 ...