The cutting height is the distance from the blades to the ground. The cutting height is
adjusted by
moving the spacers on the wheel yokes
.
Placing spacers between the
wheel arm and the wheel yoke raises the cutting height by the size of the spacer.
Removing the spacers, lowers it by the same height
(see fig. 5)
.
Be sure all wheel arms are adjusted equally. This is the only way to ensure a completely
uniform cut.
IMPORTANT: Very low cutting heights should be avoided. Damaging shock loads
occur when the blades strike the ground repeatedly. This can cause damage to
the mower.
Cutting lower than 2” under most circumstances should be avoided.
The cutting height is adjustable from 1” to 4”.
A front anti-scalp roller is also available upon request. This accessory is particularly
helpful when cutting over uneven terrain.
3.04 - Pre-Operational Check
IMPORTANT:
Check each of the following, carefully, prior to engaging the equipment:
1. The spindle bearings have been greased.
2. The belts for proper tension.
3. The oil in the gearbox.
4. The driveline cross and bearings have been greased.
5. No wrappings or foreign objects are around the blades, belts or driveline.
6. The blades are properly installed and the blade bolts properly torqued
3
.
O
PERATION
14
ABI A
TTACHMENTS
F
INISH
M
OWER
O
PERATOR
’
S
M
ANUAL
3
See Table 1, page 31.
Fig. 5
The cutting height is
adjusted by moving the
height adjustment spacers
on the wheel yokes above or
below the wheel arm.
Summary of Contents for ACYCMO72
Page 35: ...WARRANTY ...
Page 38: ...FINISH MOWER FRAME OPERATOR S MANUAL PARTS MANUAL 2 ABI ATTACHMENTS 06 2015 ...
Page 42: ...FINISH MOWER TRANSMISSION SPINDLE OPERATOR S MANUAL PARTS MANUAL 6 ABI ATTACHMENTS 06 2015 ...
Page 50: ...FINISH MOWER DECALS OPERATOR S MANUAL PARTS MANUAL 14 ABI ATTACHMENTS 06 2015 ...