off the tractor by low hanging limbs and then being run over by the tiller. Accidents
are most likely to occur with machines that are loaned or rented to someone who
has not read the operator’s manual and is not familiar with a tiller.
7. Always stop the tractor, set brake, shut off the tractor engine, remove the ignition
key, lower implement to the ground and allow rotor to come to a complete stop
before dismounting tractor. Never leave equipment unattended with the tractor
running.
8. Never place hands or feet under tiller’s deck with tractor engine running or before
you are sure all motion has stopped. Stay clear of all moving parts.
9. Do not allow riders on the tiller or tractor at any time. There is no safe place for
riders.
10. Do not operate unless all personnel, livestock and pets are 50 yards away to prevent
injury by thrown objects.
11. Before backing up, disengage the tiller and look behind carefully.
12. Install and secure all guards and shields before starting or operating.
13. Keep hands, feet, hair and clothing away from moving parts.
14. This tiller is designed for use only on tractors with 540 rpm power take off and in the
correct power range
1
.
15. Never operate tractor and tiller under trees with low hanging limbs. Operators can be
knocked off the tractor and then run over by the rotor.
16. The rotating parts of this machine have been designed and tested for rugged use.
However, they could fail upon impact with heavy, solid objects such as steel guard
rails and concrete abutments. Such impact could cause the broken objects to be
thrown outward at very high velocities. To reduce the possibility of property damage,
serious injury, or even death, never allow the rotor to contact such obstacles.
17. Frequently check blades. They should be sharp, free of nicks and cracks and
securely fastened.
18. Stop tiller immediately upon striking an obstruction. Turn engine off, remove key,
inspect and repair any damage before resuming operation.
19. Stay alert for holes, rocks and roots in the terrain and other hidden hazards. Keep
away from drop-offs.
20. Use extreme care and maintain minimum ground speed when transporting on
hillside, over rough ground and when operating close to ditches or fences. Be careful
when turning sharp corners.
21. Reduce speed on slopes and sharp turns to minimize tipping or loss of control. Be
careful when changing directions on slopes. Do not start or stop suddenly on slopes.
Avoid operation on steep slopes.
22. When using a unit, a minimum 20% of tractor and equipment weight must be on
tractor front wheels. Without this weight, tractor could tip over, causing personal
injury or death. The weight may be attained with a front end loader, front wheel
weights, ballast in tires or front tractor weights. When attaining a minimum 20% of
tractor and equipment weight on the front wheels, you must not exceed the ROPS
weight certification. Weigh the tractor and equipment. Do not guess or estimate!
O
PERATION
11
ABI A
TTACHMENTS
C
OMMAND
T
ILLER
O
PERATOR
’
S
M
ANUAL
1
See Table 3, page 30.
Summary of Contents for ARTRTL66
