EN - 11
ABIDOT
6 Putting into operation
6.2 Mounting the ABIDOT
6.2.1 Adjusting the stick-out
1
Loosen the hexagon socket screw
, but do not remove it.
2
Mount the appropriate torch adaptor
or
in the
ABIDOT
slightly lifting the
clamping piece.
3
Adjust the stick-out by means of the corresponding torch adaptor.
Slide in the torch adaptor over the locking until the desired setting is
reached.
Fig. 6 Details torch adaptor on page EN-12 and Fig. 7 Setting in torch
adapter on page EN-12
NOTICE
• Before mounting the
ABIDOT
, you must mount the corresponding
welding torch on the robot and adjust the desired stick-out at the
ABIDOT. Make sure to use the suitable torch adaptor.
1
Hexagon socket screw M3x4
2
Torch adaptor
type:
A360, A500
3
Torch adaptor type: W500,
455D TS, 505, VTS500
4
Torch adaptor type: W600,
650TS, 652D TS
5
ABIDOT
6
Clamping piece
Fig. 5
Adjusting the stick-out
10
20
10
20
15
25
5
1
2
3
4
6
NOTICE
• The torch adaptor to be used depends on the corresponding welding
torch type.
