EN - 15
ABIDOT
8 Putting out of operation
1
Switch the
ABIDOT
on. (look 1 On / Off switch on page EN-10)
2
Move the robot to the beginning of the weld
3
Reduce the distance between the
ABIDOT
and the selected start point
of the weld
are focused on
one point
Thus, the desired working point is reached.
8 Putting out of operation
1
Switch the
ABIDOT
off and remove it from the torch.
Any further steps to be carried out depend on the corresponding welding torch.
Please observe the operating instructions of the welding torches used.
1
ABIDOT
2
Laser projection
3
End of weld
4
Focused point - corresponds to
the adjusted stick-out
5
Weld
6
4 projected individual points
7
Work-piece
8
Beginning of weld
Fig. 10
Operation
1
2
3
5
6
7
8
4
CAUTION
Material damage
A collision with the work-piece or a welding device may destroy the
ABIDOT
.
• Slowly bring the robot into position.
