EN
-
36
7 Operation
iROB
®
501, iROB
®
401, iROB
®
301
F3: Switching the heat input display
The output current/output voltage and the heat input are displayed blinking after the welding process has
been completed.
The heat input is displayed in the digital display as follows:
F6: Setting the rise time
If the difference between the start welding parameters and the main welding parameter is very large, the
welding wire may burn back too much when the parameter is changed. In this case, the transition time from
the start welding parameters to the main welding parameter can be extended.
F7: Setting the decay time
If the difference between the main welding parameters and the end crater filling parameter is very large,
the welding wire may be immersed in the melt when the parameter is changed. In this case, the transition
time from the main welding parameter to the end crater filling parameter should be extended.
F8: Setting the display hold time
The welding current and welding voltage are displayed blinking in the left and right digital display after
completion of the welding process.
F12: Setting the run-on time for the cooling water pump (option)
Adjustable range
ON/OFF
Default value
OFF
Storage option
No
Description
ON: Displays the heat input.
OFF: Does not display the heat input.
Right digital display
Heat input range
Unit
0J
0 to 999
J
3J
1 to 999
kJ
6J
1 to 999
MJ
Adjustable range
0 to 10 s
Default value
0 s
Storage option
Yes
Description
Defines the rise time.
Adjustable range
0 to 10 s
Default value
0 s
Storage option
Yes
Description
Defines the decay time.
Adjustable range
0 to 60 s
Default value
20 s
Storage option
No
Description
Defines the duration for which the welding current and welding voltage
are displayed after completion of the welding process.
Adjustable range
20 to 60 min.
Default value
20 min.
Storage option
No
Description
Defines the run-on time for the coolant after completion of the welding
process (for liquid-cooled torches).
