EN - 16
BAL.0523.0 • 2019-10-17
6 Commissioning
iSTM mini
iSTM mini for ABIROB
®
G with wire brake
1
The cable assembly
is guided through the mounted iSTM mini welding torch interface
. Mount the cable assembly
in the mounting direction.
2
Disassemble the straight push-in fitting
if already mounted.
3
Mount the straight cable assembly
with seven cylinder head screws M4 × 16
on the iSTM mini
tightening torque M = 4 Nm.
4
Mount the rear cover on the iSTM mini
with 2 cylinder head screws M3 × 6
.
5
Guide the compressed air supply hose
through the hole in the rear cover
.
6
Mount the cover on the iSTM mini
7
Mount the wire brake
8
Tighten the push-in fitting Ø 6 using the screw-in aid AF11.
9
Insert the shielding gas hose and connect it to the shielding gas supply.
1
Cover
2
Cylinder head screw M4 × 16 (7 pieces)
3
Cylinder head screw M3 × 6 (2 pieces)
4
Wire brake
5
Hose for compressed air supply
6
Rear cover
7
iSTM mini
8
Cable assembly
9
Machine-side connector
10
Push-in fitting Ø 6/G1/8"
11
Screw-in aid AF11
12
Shielding gas hose Ø
6
Fig. 12
Mounting the cable assembly
iSTM mini
for
ABIROB
®
G
with wire brake
NOTICE
• The welding current port must be connected to the wire feeder.
Operating instructions for wire feeder
Mou
nting
dire
ction
1
2
3 4
5 6
7
8
10
11
12
9