EN - 22
BAL.0523.0 • 2019-10-17
8 Decommissioning
iSTM mini
8 Decommissioning
Decommissioning depends on the respective welding torch.
Observe the operating instructions of the relevant welding torch and welding power source.
9 Maintenance and cleaning
Scheduled maintenance and cleaning are prerequisites for a long service life and trouble-free operation.
NOTICE
• When decommissioning the system, ensure that the procedures for switching off the welding components are
observed.
DANGER
Risk of injury due to unexpected start
The following instructions must be followed during all maintenance, servicing, assembly, disassembly, and repair work:
• Switch off the power source.
• Close off the compressed air supply.
• Close off the coolant supply.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
DANGER
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
WARNING
Risk of injury
Serious injuries may be caused by parts swirling around.
• When cleaning with compressed air, wear suitable protective clothing, in particular safety goggles.
NOTICE
• Always wear your personal protective equipment when performing maintenance and cleaning work.
