EN - 12
BAL.0733.0 • 2021-01-11
6 Commissioning
xFUME FLEX
9
Feed the extraction hood's electric cable through the
connecting tube from the bottom.
10
Insert the extraction hood into the connecting tube and
rotate it once to secure it in place.
Without
11
Place the clamp over the metal flange and attach
it loosely.
12
Slide the connector over the profile tube until the screw
holes are aligned and then secure the connector to the
profile tube using the screw. The electric cable must be
protruding out of the metal flange.
13
Connect the electric cable on the profile tube with the
electric cable of the extraction hood.
Without
14
Use a cable tie to secure the connected cables on the
profile tube.
Without
15
Trim any protruding ends of the cable tie.
Tab. 6
Mounting the extraction arm
