xFUME FLEX
12 Disposal
BAL.0733.0 • 2021-01-11
EN - 23
12 Disposal
12.1 Welding dust
All welding dust collected must be disposed of in accordance with local regulations.
12.2 Materials
This product is mainly made of metallic materials that can be melted in steel and iron works and are thus almost infinitely
recyclable. The plastic materials used are labeled in preparation for their sorting and separation for later recycling.
12.3 Consumables
Oil, greases and cleaning agents must not contaminate the ground or enter the sewage system. These substances must be
stored, transported and disposed of in suitable containers. Observe the relevant local regulations and disposal instructions
in the safety data sheets specified by the manufacturer of the consumables. Contaminated cleaning tools (brushes, rags, etc.)
must also be disposed of in accordance with the information provided by the consumables’ manufacturer.
The disposal of dust collecting bags and disposal bags is subject to special waste regulations. The dust must not enter sewage
systems or be disposed of together with normal household waste. Observe the local and official regulations.
12.4 Packaging
ABICOR BINZEL
has reduced the transport packaging to the necessary minimum. The ability to recycle packaging
materials is always considered during their selection.
Equipment marked with this symbol is covered by European Directive 2012/19/EU on
waste electrical and electronic equipment (WEEE).
• Electrical and electronic equipment must not be disposed of with household waste.
• Electrical and electronic equipment must be collected separately and recycled in an
environmentally friendly manner.
• Please observe the local regulations, laws, provisions, standards and guidelines.
• Your local authority can provide you with information about the collection and return
of electrical and electronic equipment.
• To correctly dispose of the product, it must first be disassembled. Please note the
following information:
