-
3
-
FIGURE
2
ASSEMBLY FOR CENTRAL TUBE
Step
1
. Connect the sensor wire(A
2
) and the computer cable(F
2
).
Step
2
. Equip the cable of tension control(F3) in the slot of tension cable plastic bracket(A3) as
shown in view(A
-1
).
Fit together the large and small brass barrels and tighten by turing with your fingers as
shown in view(A
-2
).
It should look like view(A
-
3).
Step 3. Assemble support tube(F) with the base frame(A) by bolts(F6), spring washers(F5) and
washers(F4).
** ATTENTION: Take care when pushing the tubes together that the cables and wires are not
pinched.
View A
View(A
-1
).
View(A
-2
).
View(A
-
3).
